ccna:commandes_cisco
This is an old revision of the document!
Table of Contents
Commandes Cisco
Ci-dessous une liste des commandes dans l'IOS de cisco
Commandes de visualisation
- show version : afficher la version matériel et logiciel IOS.
- show flash : affiche le contenu de la mémoire flash.
- show runnning-config : affiche la configuration chargée en RAM (celle en cours d'exécution).
- show startup-config : affiche la configuration stocké en mémoire flash (NVRAM : Non Volatile…).
- show interfaces status : affiche le statut des interfaces.
- show interface fastEthernet 0/X (S0/0/X, Gig 0/0/..) : affiche des informations sur l'interface spécifiée.
- show ip(v6) interfaces (brief) : affiche les interfaces avec un contenu éventuellement bref.
- show interfaces trunk : affiche les interfaces de type trunk et les VLAN transitant sur celles-ci.
- show vlan (brief) : affiche les vlan configurés.
- show arp : affiche la table ARP.
- show cdp neighbors : affiche les périphériques réseaux voisins (Cisco Discovery Protocol).
- show access-list : affiche les règles access list configurées.
- show vtp : affiche les informations concernant Vlan Trunking Protocol.
- show spanning-tree (interface fa0/x vlan x) : affiche les informations à propos du protocole spanning tree.
- show tech-support : Affiche toutes les configurations présentes sur un matériel Cisco.
Modes de commandes
- Switch> : Mode utilisateur (sans droits d’administration).
- Switch> en : passage en mode privilégié.
- Switch# : mode privilégié.
- Switch# configure terminal : passage en mode configuration.
- Switch(config)# : mode configuration.
ccna/commandes_cisco.1746126304.txt.gz · Last modified: 2025/05/01 21:05 by alberto