ccna:commandes_cisco
This is an old revision of the document!
Commandes Cisco
Commandes de visualisation
- show version : afficher la version matériel et logiciel IOS
- show flash : affiche le contenu de la mémoire flash
- show runnning-config : affiche la configuration chargée en RAM (celle en cours d'exécution)
- show startup-config : affiche la configuration stocké en mémoire flash (NVRAM : Non Volatile…)
- show interfaces status : affiche le statut des interfaces.
- show interface fastEthernet 0/X (S0/0/X, Gig 0/0/..) : affiche des informations sur l'interface spécifiée
- show ip(v6) interfaces (brief) : affiche les interfaces avec un contenu éventuellement bref
- show interfaces trunk : affiche les interfaces de type trunk et les VLAN transitant sur celles-ci
- show vlan (brief) : affiche les vlan configurés
- show arp : affiche la table ARP
- show cdp neighbors : affiche les périphériques réseaux voisins (Cisco Discovery Protocol)
- show access-list : affiche les règles access list configurées
- show vtp : affiche les informations concernant Vlan Trunking Protocol
- show spanning-tree (interface fa0/x vlan x) : affiche les informations à propos du protocole spanning tree * show tech-support : Affiche toutes les configurations présentes sur un matériel Cisco ===== Modes de commandes ===== * Switch> : Mode utilisateur (sans droits d’administration) * Switch> en : passage en mode privilégié * Switch# : mode privilégié * Switch# configure terminal : passage en mode configuration * Switch(config)# : mode configuration
ccna/commandes_cisco.1746125845.txt.gz · Last modified: 2025/05/01 20:57 by alberto